What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 14:40
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
but this device (an Inductor) … impedes the rapid changes in the current.
The MOV will conduct when the voltage exceeds 50% of line voltage.
DC-area pediatrician on CDC urging summer camp operators to screen for measles immunity - WTOP
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
These are simplified answers to the original question, and does not change anything I wrote above.
This is where this question deviates from being a 'generic' question, and becomes more specific.
One
A fuse is a non-resetable over current circuit protector.
For this case there are devices called Metal oxide varistors (MOV).
What are some very specific groups of people you just cannot stand?
This is where the MOV conducts again, and dissipated the energy.
First Sentence:
There are two important concepts here.
The third is lightning and “how it gets conducted into a home.”
I post the exact comment here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
He then describes Rainy Season and Lightning.
so, what happens?
Jared Isaacman’s Plans For NASA - NASA Watch
Edit 2024–10.
This device then solves the entire problem.
[old diagram got deleted by accident]
2024–10–10[John johnson John Johnson ]
What is lightning?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Where did cosmic rays come from? Astrophysicists are closer to finding out - Phys.org
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Summer rentals in the Hamptons are down 30% - CNBC
One is “what exactly is in a ‘surge protector’ ? ”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
what exactly is a ‘surge’ protector?
If there is an abandoned house with no owner, can I live in it?
This is 'the assistant's answer'
It also is a device that limits the change in current flow.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
An AC voltage/ current source, and an ac inductive load.
He then asserts :
Upvotes:
Can the fuse protect the electronic devices from lightning instead of a surge protector.
But… the neutral is now “floating” because of the 1 ohm resistance.
Barnstars:
(Dc diagram shown, AC is similar).
nine
A circuit breaker is similar, but is resettable.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
a photo is worth a thousand words.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Here is a simplified AC power diagram.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These devices are installed between the “hot” and “neutral” and protective ground.
At least they know the answer if they wanted it.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
So, the voltage could go up to 500 volts, and the fuse will not open up.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
the problem then depends on "how fast does the fuse operate?".
The other is “what does a “fuse” do?”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What does a fuse do?
There are three different concepts here that are getting confused.
2024–10–16 [ OO OLAOYE OYEBODE ]
But it can get overloaded, and no longer works.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then describes the function of a fuse.
In schematic diagrams this is the symbol for a fuse:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
[image of Common-mode choke]
It seems Mohan does not understand the difference between a comment and an Answer.
Now when you have a certain ac resistance, then a current flows in a loop.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At one ohm, the resistor has a maximum of 1 watt power.
Because the load is inductive, the current lags the voltage.(by a bit).
eight
but I think this circuit , shows a few more pieces.
The bolt then partially travels down the line to your home.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”